•
Avoid putting an SE SCSI device on the same bus as a tape drive because the SE device will slow
the tape drive to SE speed and reduce the allowable cable length.
SCSI addresses
NOTE:
The HBA also has a SCSI address, which is typically 7.
Verify that each device on the bus has a unique SCSI address. If these pre-configured addresses will
not be unique on a bus, you will need to change the SCSI address of one or more of the tape drives
during the installation process.
•
MSL2024:
For full-height tape drives the default SCSI address is 4. For half-height drives, the default
SCSI address for the bottom drive is 4 and the default SCSI address for the top drive is 5 as shown
in
Figure 15 MSL2024 parallel SCSI tape drive default SCSI addresses
.
1. Tape drive with SCSI address 4
2. Tape drive with SCSI address 5
•
MSL4048:
For full-height tape drives the default SCSI address is 4. For half-height drives, the default
SCSI address for the bottom drive in each full-height drive bay is 4 and the default SCSI address
for the top drive is 5 as shown in
Figure 16 MSL4048 parallel SCSI tape drive default SCSI addresses
.
1. Tape drives with SCSI address 4
2. Tape drives with SCSI address 5
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide
39
Summary of Contents for StorageWorks MSL2024
