HP HP-UX SNAplus2, Administration Manual

Page: 238 / 398

238 Chapter 10
Managing SNAplus2 from NetView
Using the Host NetView Program
Step 5. If you are using 3270 emulation to access NetView, follow the
instructions in HP-UX SNAplus2 3270/3179G Users Guide for ending
3270 emulation when you have finished issuing commands.
NetView Screen Display
The layout of the NetView screen varies with different versions of
NetView at different hosts.
The display includes an input area at the bottom of the screen; this is the
area into which you can type commands. The line
???
divides the main
screen area (where NetView displays responses to your commands) from
the input area.
Changing the Size of the Command Input
Area
By default, the input area is one line, but for some of the longer
commands you need more than one line. On some versions of NetView,
you can specify an input area of one, two, or three lines by using the
input
command. To do this, type the following command:
input
n
In this command, n is
1
,
2
, or
3
, indicating the number of lines you want.
If this command does not work on the version of NetView you are using,
contact your NetView support personnel.
Overview of RCF Command Syntax
Both SPCF and UCF commands use the RCF command syntax:
runcmd sp=
spname
, appl=
component
,
commandtext
NetView uses the
runcmd
utility to send a command string to a remote
system. The command includes the following parameters:
sp
=
spname
Indicate the service point name (defined at NetView)
that corresponds to the SNAplus2 node. The host
NetView personnel can give you this information.
appl
=
component
Indicate the name of the SNAplus2 component to
which NetView should send the command, as follows: