HP HP 4062F, Installation Manual

Page: 154 / 174

T est Procedure
1. Select
NNNNNNNNNNNNNNNNNNNNNNNNNN
4062F AC softkey from PV4062.F main men u. Preparation page is display ed as
sho wn in Figure 6-44. Conrm that y ou ha v e prepared ev erything as describ ed on this
page.
If COM blo c ks need to b e redeclared, ST AR T program runs automatically to redeclare
them. If so, conguration page is display ed temp orarily , then preparation page is display ed.
d a
c b
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
HP 4062F Performance Verification Program for AC function
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
BEFORE START
1. Confirm the Pin Boards for 4062F are installed at least at Pin4, 8, 12, 16,
20, 24, 28, 32, 36, 40, 44, and 48 in the SWM.
2. Connect the Probe to HP54121A INPUT 3 as follows:
[HP 54121A INPUT3] <-> [20dB ATT] <-> [SMA-BNC Adapter] <-> [BNC Cable]
3. Remove 50 Ohm terminator from PG1 TRIG OUT cable, then connect the cable
to HP 54121A TRIG terminal.
4. Set the HP-IB address of HP 54120B to 2707 (To change address, select
"HP-IB ADDRESS" softkey.
5. Mount the HP 16354F atop the SWM.
Read the above message, then press "NEXT" to continue.
User 1 Caps Running
aaaaaaaaaaaaaaa
NEXT
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
Figure 6-44. Preparation P age for 4062F A C
2. Install the pulse test mo dule (HP 16354F) on the SWM.
6-42 System V erification