C
OMMISSIONING
8030HEPTA/GPS GPS - NTP Time Server with 2x 10/100/1000 MBit LAN Interface - V04.00
31 / 178
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
6.4
Establish the Network Connection via Web Browser
Ensure that the network parameters of the Time Server 8030HEPTA/GPS
are configured in accordance with the local network before connecting the
device to the network.
Connecting a network to an incorrectly configured Time Server
8030HEPTA/GPS (e.g. duplicate IP address) may cause interference on
the network.
The Time Server 8030HEPTA/GPS is supplied with:
ETH0 with static IPv4-address
IPv4 address:
192.168.0.1
IPv4 Network mask: 255.255.255.0
Gateway:
not set
ETH1 with DHCP
In case it is not known whether the Time Server 8030HEPTA/GPS with a
Factory Default setting causes problems in the network, the basis network
parameterization should be executed via a "Peer to Peer" network connec-
tion.
Request the required network parameters from your network administrator
if those are unknown.
The network connection is made via a LAN cable and RJ45 plug (recommended cable type:
CAT5e or better).
6.5
Network Configuration for ETH0 via LAN through
hmc
soft-
ware
After connecting the system to the power supply and creating the physical network connection
to LAN interface of the Time Server 8030HEPTA/GPS, the device can be searched for on the
network via the
hmc
Software. Then
the base LAN parameters (IPv4 address, IPv4 netmask
and gateway or DHCP) may be adjusted in order to allow accessibility of the Time Server
8030HEPTA/GPS for other systems on the network.
The SEARCH Function of the
hmc
Software (Network Configuration As-
sistant)
requires
for location and recognition of the wished Time Server
8030HEPTA/GPS that the
hmc
-computer and the Time Server
8030HEPTA/GPS are
in the same LAN
.
