I
NSTALLATION
8030HEPTA/GPS GPS - NTP Time Server with 2x 10/100/1000 MBit LAN Interface - V04.00
26 / 178
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
5.1.3.1 Safety and Warning Instructions
Please read these instructions fully in order to guarantee safe operation of the equipment and
to be able to use all the functions.
Caution:
Never work on an open unit when voltage is applied!
Danger to life!
The Time Server 8030HEPTA/GPS is an installation device. Installation and commissioning
may only be carried out by suitably qualified specialist personnel. In doing so the respective
country-specific specifications must be observed (e.g. VDE, DIN).
Before commissioning ensure that:
•
The power supply has been connected correctly and electrical shock protection is in
place
•
The earth wire is connected
•
All supply cables are correctly sized and fused
•
All output cables are suitably sized or specially fused for the max. output current of
the equipment
•
Sufficient convection is guaranteed
The equipment contains life-threatening components and a high level of stored energy.
5.1.3.2 Power Supply Unit Specifications
All AC power supply specifications are described in
Chapter 12 Technical Data
5.1.3.3 Fusing
Pay attention to the correct fusing of the power supply when connecting the Time Server
8030HEPTA/GPS.
The corresponding performance data can be taken from the equipment nameplate. The Time
Server 8030HEPTA/GPS is currently fitted with a power supply unit with a power consumption
of max. 20VA (Standard) or 40VA (47-63Hz).
If the internal fuse (device protection) trips it is highly probable that the
equipment is faulty. In this case the device should be checked in the fac-
tory.
