C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
148
MAXPRO NVR 5.0 Installation and Configuration Guide
6
To configure Panomorph settings
1.
On the
Camera
page, for the required camera, click
on the left corner to open the
Figure 6-23 Panomorph Settings
2.
Under
General > 360 Settings
•
Select the
Enable Panomorph
check box to enable the Panomorph feature.
•
Select the
Mounting Position
. You have three options to choose from:
Wall
,
Ceiling
,
and
Ground
.
•
Select the
Mode
for the camera. The available modes are
PTZ Mode
,
Quad Mode
,
and
Perimeter Mode
. The default mode is
PTZ Mode
.
•
Select the
Lens ID
for the camera. The supported lens ids in v3.5 or later are
A0**V,
A0IFV, A0NKV, A1UST
,
A8TRT, B0QQV, B4QQV, B5SST, B6SST
and
B8QQT
. By
default AO**V Lens ID is selected. For Sony 360 camera the A8TRT lens ID is
selected automatically.
3.
Click
Save
.
Note:
•
To view live video from Immervision certified cameras, Refer Video Viewing
Options from Immervision Enabled Cameras section in
MAXPRO NVR
Operator’s Guide.
•
The recommended Aspect Ratio for Immervision Certified cameras is 4:3.
Configuring Oncam Grandeye Cameras
The integration of the unique 360-degree Oncam Grandeye H.264 IP cameras in MAXPRO
NVR enables video surveillance, acquisition and tracking that identifies suspicious behavior
enabling the interrogation and verification of a potential threat. This in-turn provides the
necessary intelligence needed to make a measured response to any critical situation.
Summary of Contents for MAXPRO NVR Hybrid PE
