CM4 Four-Point Continuous Monitor
CM4 Technical Manual
7-2
7.1 Introduction
Use the Set-Up Menu to:
• Configure the CM4
• Program monitoring sequences and parameters
The Set-Up Menu offers seven primary functions (see Figure 7-1).
7.1.1 Enabling/Disabling the Keypad
The CM4 includes a function that allows enabling and disabling of
the keypad. The function toggles between enabling and disabling the
keypad when a passcode is entered via the keypad.
NOTE:
The keypad enable function and all passcodes begin with “9”
number.
The keypad locking feature is disabled by default. However, it may be
enabled by setup function 3.6.1
While in the Monitor Mode, entering the proper passcode toggles
between the keypad lock and unlock conditions. The factory-set default
is 90000.
For all subsequent CM4 operation, you must use a passcode to
change between keypad lock and unlock (i.e., enabled and disabled).
For passcode information, refer to
.
3
SET-UP MODE
3.1
POINT ENABLE
3.2
POINT PARAMETERS
3.3
OUTPUT OPTIONS
3.3.1
COM PORT
3.3.2
PRINTER PORT
3.3.3
PRINTER FORMAT
3.3.4
RELAY STATE
3.3.5
2mA FAULT OPER
3.3.6
EN/DIS DUTY CYCLE
3.4
CONFIGURATION
3.5
DATE & TIME
3.5.1
DATE FORMAT
3.5.2
SET DATE & TIME
3.5.3
SET DISPLAY CYCLE
3.5.4
SET TWA TIME
3.5.5
SET IDLE TIME
3.5.6
SET DUTY CYCLE
3.6 ACCESS SETUP
3.6.1
END/DIS KBD LOCK
3.6.2
EN/DIS MENU PASSWD
3.6.3
SET PASSWORD
3.7 MAINT. SET-UP
3.7.1
CHEMCASS CTR
3.7.2
INT. FILTER LIFETIME
3.7.3
EXT. FILTER LIFETIME
Figure 7-1: Set-Up Menu
珠海司福斯特科技有限公司
www.safedtech.com
