Vehicle care 209
Diesel fuel system
bleeding
The system requires bleeding if the
vehicle has run out of fuel.
Note
• A minimum of 10 L of diesel
fuel must be in the tank for
the bleeding operation to work
correctly.
• It is possible to restart the engine
if the tank has been run dry. A
delayed start can be expected.
1. Turn the ignition control knob to
the on position for approximately
5 seconds.
2. Turn the ignition control knob to
the lock position.
3. Repeat Steps 1 and 2 five times.
4. Turn the ignition control
knob to the start position for
approximately 40 seconds.
5. If the engine does not start, wait
at least 5 minutes and try again.
If the engine still does not start,
contact a Holden Dealer.
Bulb replacement
Contact a trained service technician
if unsure about the bulb replacement
process.
When replacing bulbs:
• Turn the ignition control knob to
the lock position.
• Turn off related switches.
• Fit bulbs of the specified
wattage only.
• Do not touch bulbs or reflectors
with bare hands.
• Clean stained bulbs with
methylated spirits.
• As headlamp aiming is a safety
item it is recommended that you
have it carried out by a Holden
Dealer.
Bulbs to be changed by
a Holden Dealer
• Sun visor mirror lamps
• Exterior mirror lamps
• High mount stop lamp
• Front fog lamps
• Stop/Tail lamps
Caution
Condensation may temporarily
appear on the inside of exterior
lamp lenses after rain or washing
the vehicle. Condensation occurs
when there is a temperature
difference between the inside and
outside of the lamp allowing a
fine mist on the inside surface of
the lamp lens. This condensation
will disappear when the vehicle is
in a dry environment or the lamp
is on. If water does collect in the
lamp, contact a Holden Dealer.
BOOK_MY14_CAPTIVA 7.indb 209
19/11/2013 2:57:13 PM
