HIKVISION DS-K1T605 Series, User Manual

Page: 77 / 107

2. On the navigation bar on the left, enter Advanced Function
More Parameters .
3. Select an access control device in the device list and click Face
Recognition Terminal.
4. Set the parameters.
Note
These parameters displayed vary according to different device
models.
COM
Select a COM port for configuration. COM1 refers to the
RS-485 interface and COM2 refers to the RS-232 interface.
Face Picture Database
select Deep Learning as the face picture database.
Authenticate by QR Code
If enabled, the device camera can scan the QR code to
authenticate. By default, the function is disabled.
Blacklist Authentication
If enabled, the device will compare the person who want to
access with the persons in the blacklist.
If matched (the person is in the blacklist), the access will be
denied and the device will upload an alarm to the client.
If mismatched (the person is not in the blacklist), the access
will be granted.
Save Authenticating Face Picture
If enabled, the captured face picture when authenticating
will be saved on the device.
MCU Version
View the device MCU version.
5. Click Save.
Set RS-485 Parameters
You can set the access control device's RS-485 parameters
including the baud rate, data bit, the stop bit, parity type, flow
control type, communication mode, work mode, and connection
mode.
Steps
Note
The RS-485 Settings should be supported by the device.
1. Enter the Access Control module.
2. On the navigation bar on the left, enter Advanced Function
More Parameters .
3. Select an access control device in the device list and click
RS-485 to enter the RS-485 Settings page.
4. Select the serial port number from the drop-down list to set
the RS-485 parameters.
5. Set the baud rate, data bit, the stop bit, parity type,
communication mode, working mode, and connection mode in
the drop-down list.
68