HIKVISION DS-K1T605 Series, User Manual

Page: 34 / 107

After network configuration, system parameters configuration
and user configuration, you can go back to the initial page for
identity authentication. The system will authenticate person
according to the configured authentication mode.
You can authenticate identity via 1:1 matching or 1:N matching.
1:N Matching
Compare the captured face picture or the collected fingerprint
picture with all face pictures or all fingerprint pictures stored in
the device.
1: 1 Matching
When swiping card, compare the captured face picture or the
collected fingerprint with the information stored in the card.
8.6.1 Authenticate via 1:1 Matching
Steps
1. On the Initial page, tap 1:1 at the lower right corner of the
page to enter the 1:1 matching page.
2. Input the employee ID.
3. Select an authentication type to authenticate via face picture,
fingerprint, or password.
Note
Tap to switch to the password entering page. You can enter
the super password or duress code to authenticate.
8.6.2 Authenticate via Other Types
Steps
1. According to the configured authentication mode, authenticate
by comparing face pictures, fingerprints or by swiping card.
Face Picture Authentication
Stand in front of the device. Position your face looking at the
camera and the device will enter the face picture
authentication mode.
Note
For detailed information about authenticating face picture,
see Tips When Collecting/Comparing Face Picture.
Fingerprint Picture Authentication
Scan your fingerprint on the fingerprint module of the
device. For detailed information about scanning fingerprint,
see Tips for Scanning Fingerprint.
Authentication by Swiping Card
Swipe card above the card swiping area.
2. If the user has no other authentication modes, the
authentication is completed. If the user has other
authentication modes after the first authentication, follow the
instructions to continue authenticating until the authentication
is completed.
8.7 System Settings
On the System Settings page, you can set the system basic
parameters, set the fingerprint parameters, set the face picture
parameters, and upgrade the firmware.
25