Click Partly Restore to restore all parameters except for admin
user information, wired network, Wi-Fi network, detector
information, and peripheral information to default ones.
Click Restore All to restore all parameters to the factory
settings.
Import Configuration File
Click View to select configuration file from the PC and click
Import Configuration File to import configuration parameters
to the device.
Export Parameters
Click Export Configuration File to export the device
configuration parameters to the PC.
Upgrade File
Click View to select an upgrade file from the PC and click
Upgrade to upgrade the device remotely.
Note
Do not power off when the device is upgrading.
Certificate Standard
Click System → System Maintenance → Certificate Standard to
enter the certificate standard settings page.
You can switch between EN Standard and General Standard
mode.
The device applies EN Standard by default.
Note
When you select EN Standard, the user permission and arming
parameters will conform to the EN Standard.
Local Log Search
You can search the log on the device.
Click System → Log to enter the Local Log Search page.
Figure 4-33 Local Log Search Page
Select a major type and a minor type from the drop-down list, set
the log start time and end time and click Filter. All filtered log
information will be displayed in the list.
You can also click Reset to reset all search conditions.
4.3.8 Check Status
After setting the zone, repeater, and other parameters, you can
view their status.
Click Status. You can view the status of zone, relay, siren, battery,
communication, and repeater.
42
