Section 4
♦
Operating the CMN-41
38
CMN-41 Series Installation and Operation Handbook
Copyright © 2009, Harris Corporation
Setting Display Options
Press the ZOOM button to cycle through these display views:
•
Expand the center
•
Expand the upper-left quadrant
•
Expand the upper-right quadrant
•
Expand the lower-right quadrant
•
Expand the lower-left quadrant
•
Normal view
Vector Zoom is helpful when an increased resolution of phase or saturation is required.
Placing the Vector Display in Line Select Mode
Pressing the LINE button enables monitoring of a single line of a video
signal. This enables Line Select to monitor individual areas of the entire
image. To view a line in Line Select mode:
1.
Press the LINE button to place the selected vector display in Line Select mode. At
the bottom-center of the display, the Line number and the Odd or Even field
appear, as shown in
Figure 4-19
.
Figure 4-19. Establishing Line Select
NOTE
: In a Progressive (p) format, odd and even selection is not available.
2.
Press the Up/Down arrow knob to alternate between Odd and Even fields.
3.
Rotate the Up/Down arrow knob to select the line to be displayed, or press the
SHIFT function button to use the numeric keypad to enter the line number.
Vector Cursor Selections
Cursors are available for precise measurement of vector phase (in
degrees). Press the CURS button on the front panel to enable the cursors
for the selected display. The Phase Cursor indications are shown in
Figure 4-20
.
