8.1
8 - Menu 4 Toolbox
Menu 4 Toolbox
Menu 4.1 Measure
This is a simple electronic trip meter. You can measure distance. If the implement width is entered in menu [4.1.3 Working
width], area can also be measured in menu [4.1.2 Area].
1.
Press Clear to clear the value.
Following submenus are possible:
Menu 4.2 Service intervals
Service intervals and a nozzle check are programmed into the Controller. This makes it easier for the operator to remember
the service intervals.
From the factory, the Controller is set up with three service and a nozzle check reminder.
Entering the above menu’s will display the hours remaining until next service. The importer or dealer may have added a
“Miscellaneous service” interval. If no interval is set, [Miscellaneous service not defined] is shown.
Press Enter to register service or control, if displayed when switched on. The warning
will remain present until the service
interval is reset.
Menu 4.3 Service interval reset
To reset service interval, go to relevant interval menu listed:
1.
Press Clear to reset hour meter.
2.
Press Enter to confirm.
Menu 4.4 Reserved
Reserved function - This menu is not used
[4.1.1 Measure Distance]
Measures a distance being travelled.
[4.1.2 Measure Area]
Measures the area the boom covers at a travelled distance.
[4.1.3 Setup working width]
Menu for entering the boom working width to be measured.
[4.1.4 Stop-watch]
Measures the time being used.
[4.1.5 Alarm clock]
Can give an alarm at a preset time.
Menu & interval
Hours
Action
[4.2.1 Check filters]
10
See sprayer instruction book, Maintenance.
[4.2.2 Grease boom]
50
See sprayer instruction book, Maintenance.
[4.2.3 Grease track and center]
250
See sprayer instruction book, Maintenance.
[4.2.4 Miscellaneous service]
0
Not defined from factory.
[4.2.5 Check nozzles]
10
Check flow rate. Change nozzles if more than 10% of rated flow.
Menu & interval
Hours
Action
[4.2.1 Check filters reset]
10
See sprayer instruction book, Maintenance.
[4.2.2 Grease boom reset]
50
See sprayer instruction book, Maintenance.
[4.2.3 Grease track and center]
250
See sprayer instruction book, Maintenance.
[4.2.4 Miscellaneous service]
-
Not defined from factory.
[4.2.5 Check nozzles]
10
Check flow rate. Change nozzles if more than 10% of rated flow.
Summary of Contents for ISOBUS VT
