HappyJapan HCS3, Instruction Book

Page: 11 / 364

-S3 -9 2_4a U901
2-4a
SETTING UP THE MACHINE
6. Loosen the screw with a offset driver and remove the
red shipping collars that are equipped on the both
side of the guide bar. (Keep the shipping collars. It is
necessary when packing.)
7. Put the carriage and carriage arm together with screw
(M4 X 8 2 pcs).
2 pins in the upper carriage arm will fit into holes on
the lower carriage.
8. Remove the fixing screw (M3 1 pcs) that fixing the arm
indicated by the arrow. (Keep the fixing screw.
It is necessary when packing.)
9. Raise slowly the control box to the front then fix it with
2 supplied screws (M4 1 pcs).
10. Connect the cable of carriage to the machine with
fixed screw.
11. Install the arm for tubular embroidery. Please refer to
(page 6-1) “Installing and removing the frame base”.
Or, Install the cap frame for the cap embroidery.
Please refer to (page 7-1) “Installing and removing the
cap drive frame”.
12. Insert built-in stylus into the holder (slot) of control
box.
When taking the machine apart in case of packing,
the process is opposite of assembling the machine.
Please do exactly the opposite way of assembling.
When packing the machine up for transportation,
be sure to select the sixth needle and fix it with
shipping collars on the both side of the guide bar.
9
6
7
8
10
12