Hakko Electronics Monitouch V9 Series, Connection Manual

Page: 63 / 430

1.4 Hardware Settings
1-51
Basics of ethernet settings
Local Mode Screen
Make prohibition settings for Local mode.
For more information, refer to the V9 Series Reference Manual.
IP address
This is an address that is used for recognizing each node on the Ethernet and should be unique.
The IP address is 32-bit data which consists of the network address and the host address and can be classified into classes A to C depending
on the network size.
<Notation>
A string of 32-bit data is divided into four, and each segment delimited with a period is in decimal notation.
Example: The IP address in class C shown below is represented as “192.128.1.50”.
11000000 10000000 00000001 00110010
<Unusable IP addresses>
 “0” is specified for one byte at the extreme left. Example: 0.x.x.x

“127” is specified for one byte at the extreme left (loop back address). Example: 127.x.x.x
 “224” or more is specified for one byte at the extreme left (for multi-cast or experiment). Example: 224.x.x.x
 The host address consists of only “0” or “255” (broadcast address). Example: 128.0.255.255, 192.168.1.0
Port No.
Multiple applications are running on each node, and communications are carried out for each application between the nodes. Consequently,
it is necessary to have a means to identify the application that data should be transferred to. The port number works as this identifier. Each
port number is 16-bit data (from 0 to 65535).
The V9 series uses the port for screen program transfer (8001), PLC communication (as desired), and the simulator (8020). Set a unique
number in the range of 1024 to 65535. For a PLC or a computer, set the port number in the range of 256 to 65535. It is recommended to set
a greater number.
Default gateway
A gateway and a router are used for communication between different networks.
The IP address of the gateway (router) should be set to communicate with the node(s) on other networks.
Subnet mask
A subnet mask is used for dividing one network address into multiple networks (subnet).
The subnet is assigned by specifying a part of the host address in the IP address as a subnet address.
<Unusable subnet masks>

All bits are set to “0”. ..... 0.0.0.0
 All bits are set to “1”. ..... 255.255.255.255
0
1 0
1 1 0
Class A
Class B
Class C
Network
address (7)
Host address (8)
Host address (24)
Network address (14) Host address (16)
Network address (14)
255. 255. 255. 0
1 0
11111111 11111111 11111111 00000000
Class B
Subnet mask
Host address (16)
Network address Subnet address
Network address (14)
Host address