Hakko Electronics Monitouch V9 Series, Connection Manual

Page: 414 / 430

20.2 Temperature Controller/Servo/Inverter Connection 20-19
20.2.1 SJ300 Series
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Inverter
Parameter
The communication parameters can be set using keys attached to the inverter.
Be sure to match the settings to those made under [Communication Setting] of the editor.
(Underlined setting: default)
Terminating resistance
Short-circuit RP-SN (control terminal block) on the terminal inverter.
Item Setting Remarks
Connection Mode
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 bps
Data Length 7 / 8 bits
Stop Bit 1 / 2 bits
Parity None / Odd / Even
Target Port No. 1 to 32
Function Code Function Name Setting Remarks
Basic setting
A001
Frequency
command selection
03: RS-485
To give the frequency command from V9,
always select “03”.
A002
Operation command
selection
03: RS-485
To give the operation command from V9,
always select “03”.
Communication
function
adjustment
C070
Data command
selection
03: RS-485
C071 Baud rate selection
04: 4800 bps
05: 9600 bps
06: 19200 bps
C072
Communication
station number
selection
1. to 32.
C073
Communication bit
length selection
7: 7 bits
8: 8 bits
C074
Communication
parity selection
00: No parity
01: Even parity
02: Odd parity
C075
Communication
stop bit selection
1: 1 bit
2: 2 bits
C078
Communication
latency
0. to 1000. (msec)