Hakko Electronics Monitouch V9 Series, Connection Manual

Page: 329 / 430

16-76 16. Fuji Electric
16.2.27WA5000
Communication Setting
Editor
Communication setting
(Underlined setting: default)
*1 If the send delay time is too short, “Communication Error “Format”” may occur. If this error occurs, set the send delay time to 5 msec or
longer.
Digital Panel Meter
The communication parameters can be set using keys attached to the front of the digital panel meter.
Be sure to match the settings to those made under [Communication Setting] of the editor.
(Underlined setting: default)
* The communication function of the temperature controller can be selected with the output unit specified at the time of purchase. Select a
model on which RS-485/RS-232C communication is available.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
*1 To perform zero calibration (0000), specify a value other than 0.
Item Setting Remarks
Connection Mode
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 / 38400 bps
Data Length 7 / 8 bits
Stop Bit 1 / 2 bits
Parity None / Even / Odd
CR / LF CR / CR/LF
Target Port No. 1 to 31
Send Delay Time 0 to 255 msec *1
Parameter Item Setting Example Remarks
BAUD Baud rate setting
4800: 4800
9600: 9600
192: 19200
384: 38400
9600
DATA Data length setting 7: 7 bits
8: 8 bits
7 bits
P.BIT Parity bit setting
E: Even
o: Odd
n: None
E: Even
S.BIT Stop bit setting
2: 2 bits
1: 1 bit
2: 2 bits
T- Delimiter setting
cr.LF: CR/LF
cr: CR
cr.LF: CR/LF
ADR Unit ID setting
01 to 31
(default: 00)
01 Specify a value when using RS-485 connection.
Device Memory TYPE Remarks
DSP (display) 00H
CMP (comparator) 01H
SCL (scaling) 02H
CAL1
(calibration 1)
*1
03H
CAL2 (calibration 2) 04H