S
45mm connector
bolt
fitting the keyed end of the brace into the
tep 3: Brace to End Assembly
Assembly
ssembly
Br
– ¼”
(longer)
4 – Rectangle Nuts
1 – Alan Wrench
¾
Connect the brace to the Left and Right Ends by
slots of the Frame Ends. Line up the Frame End holes with the opening in the brace. (Remember to
keep the brace’s keyed end up).
¾
Push a connector bolt through the Frame End hole and into the open slot of the brace.
¾
Thread a rectangle nut onto the end of the
bolt, so that it rests in the cross portion of the
slot (see close-up below right).
connector bolt, holding the nut in place.
¾
Repeat this process to connect the
remaining three brace ends.
Parts Needed: Left Frame End
Right Frame End A
Two
ace
Assemblies
4
x 45mm Connector Bolts
¾
Using an Alan Wrench tighten the
Key
rectangle
nut
45mm connector
bolt
Cross Portion
of slot
Right Side
45mm connector
bolt
9
