Sub-Assembly 6: Attaching Left Gear Linkage and Rear Lower Speed Control Lever
Parts Needed: 1 – Left Gear Linkage
1 – Rear Lower Speed Control Lever
1 – ¼” x 40mm Connector Bolt*
1 – ¼” x 60mm Connector Bolt
3
¾
¾
¾
e end of the
n w th a
ck nut on the
3 – ¼” Flat washer
2 – ¼” Nylock Nut
*From this point forward, please note that any place you use a 40 mm bolt, you may substitute a 45 mm (we have includ
extra 45 mm bolts in your packet), in case the 40 mm doesn’t give you enough length (due to slight variances in wood thickness).
NOTE! The next few steps (through Sub-Assembly 10) are reversible—they can be completed on
either the Right or Left Handle Assemblies according to your preference. The illustrations show parts
going on the right side.
Position the Left Gear Linkage and the Rear Lower Speed Control Lever onto the 40mm and 60mm
connector bolts as pictured.
With the end of the bolts coming through those two parts, put a flat washer on the end of both
bolts
¾
Next, put th
60mm bolt through the Lower
Rear Handle and faste
flat washer and nylock nut.
¾
NOTE:
When tightening
nylock nuts at movable points
like this one, it is important not
to over-tighten. Tighten this
nylock just enough to hold the
washer against the wood, but
loose enough to allow it to turn
with your finger.
¾
Thread a nylo
end of the 40mm bolt and
tighten it completely.
40mm connector
bolt
60 mm connector
ylock
ed
i
1/4 n
nut
bolt
1/4 flat
he
Left Gear
Rear Lower
washer
S
1/4 f at
l
was
r
Linkage
peed control
Lever
23