¾
Next place the Ball Swival into the rounded out part of the Ball Clamp and sandwich it with the
other Ball Clamp, put the ends of the two carriage bolts through the two ¼” holes of the second clamp.
¾
Connect to two clamps by placing a flat washer and wing nut on the end of each bolt. Hand-
tighten both wing nuts.
To fasten the Pointer into the ball, place it in the large hole and thread a 1 ¼” Thumb Screw into
¾
ired part of the Pointer.
The Pointer can be aimed almost any direction and can be adjusted for length out of the ball.
¾
ideal
ext
¾
the metal insert already in the ball.
Continue threading the Thumb screw until it clamps down onto the des
This entire assembly can be made to clamp vi
placement for following patterns laid on the table t
amp it to the Lower Rear Handle (see n
picture).
rtually anywhere on the Carriage Assembly. The
op is to cl
31
