Step 7: Pole Mount End to Frame End Assembly
4 – 1½” Fender Washers
4 – 5/16” Wing Nuts
Now you are ready to attach the Pole
Mount Ends to the rest of the End Assembly.
First, position the Pole Mount Ends in the
inside of the End Assembly.
End
carriage bol
¾
Place a fender washer and wing nut on
each bolt.
¾
As you tighten, make sure the part is level
by looking at the bottom of the Pole Mount
End and the grooved lines on the inside of the
Frame End Piece. (A good estimated setting is
to line up the bottom of the Pole Mount End
on the 3
rd
line up on the set of lines closest to
the table tops. However , you will readjust this
to your machine later).
¾
Complete this step for both sides.
¾
¾
Holding the outer side of the Pole Mount
to the slots of the End Piece, fit the two
ts through the slots.
Step 8: Rail Assembly
3 or 4* – 70” (Longer) Rails
3 or 4* – 34” (Shorter) Rails w/ coupler
Parts Needed:
¾
If you are setting up your frame in Crib Size, you will be
ssembly:
For Queen Size, these parts are also required:
5/
g
*Needed with Optional Fourth Pole
using the Long 70” Aluminum Rails by themselves. The Queen
Size set-up requires the following a
¾
Construct your queen size rails by connecting the long and
short aluminum rails using the aluminum connectors.
cap
cog
wheel
Inside View
16 win
nut
round end
cap
34 inch
rail
Queen Size
coupler
70 inch
rail
square end
Left End Assembly
fender washer
Right End Assembly
Inside View
fender
washer
5/16 wing
nut
12
