¾
Pla
apply pressure to the tracks to remove any play of gaps.
Note:
You have now completed the frame portion of your Grace Machine Quilter.
If you
assembled your frame in the crib size, do not be concerned that you have extra hardware.
Keep
these in the baggy and save them for future use
ce a ¼” flat washer and ¼” wing nut onto the end of the bolt. Before tightening the wing nut,
¾
.
¾
Before proceeding, take the hardware packet marked “C” and remove the hardware.
We
recommend that you stand up all the flat-head connector bolts in line and put them in order of size. This
will help you distinguish them as you move through each step, as many sizes are very similar.
Carriage Sub-Assemblies
Sub Assembly 1: Wheels to Top and Bottom Plates
Parts Needed: 1 – Top Plate
1 – Bottom Plate
8 – Wheels
¾
NOTE! The bolts and w
the platform.
¾
First, turn the Top and B
plate has four places for wheels to be installed.
¾
The hardware
arked with an “C”.
e is a bolt wall and a washer wall surrounding this
slot. Using the diagram as a guide, place a hex head bolt into the hole on the bolt side of the slot.
¾
gh the hole, through the wheel, and through the hole on the opposite wall.
¾
Place a washer on the end of the bolt. At this point
place, lining
nce d
k nut onto the end of the bolt and tighten it completely.
¾
Repeat this process for the other seven roller bearings. After each one is installed turn it to make
sure it rotates with no problems.
8 – ¼” x 1” Hex Bolt
8 – ¼” x Flat washers
8 – Nylon Lock Nut
heels may be a tight fit going into
ottom Plates upside down. Each
for this step is found in the separate hardware packet
To install a wheel you need a ¼” x 1” hex head bolt, a ¼” flat washer and a nylon lock nut.
ere the wheel will sit. Ther
Close Up of Wheel Assembly
m
¾
¾
Identify the slots wh
Push the bolt throu
you need to turn the bolt head so it slips into
1/4 X 1
hex bolt
washer
1/4 nylock
nut
up flush with the shape of the wall.
¾
O
one, place a nylon loc
Bottom Plate
wheel
1/4 flat
wheel
1/4 X 1
hex bolt
1/4 flat
washer
1/4 nylock
nut
Top Plate
wheel
1/4 flat
washer
1/4 nylock
nut
1/4 X 1
hex bolt
18
