Step 1
¾
With the rails now in place it is time to adjust the frame to the rails.
work
ere is no
end of the rail and the End Piece.
snuggly with no gaps into the end pieces.
be able to roll freely.
NOTE! As you tighten the bolts connecting the braces, be sure the brace pieces a
with each other so that there is no sagging. You may eye sight along the top edge
straightness.
¾
Also tighten the bolts that attach the Center Leg support assembly, making sure they are properly set
to hold up the table.
1: Frame Adjustment
This adjustment will only
gap between the
They should still
re aligned
to confirm
¾
NOTE! Be aware that as you apply the table tops (in step 13), it may be necessary to
readjust the braces so that holes line up.
Step 12: Right and Left Angled Leg Brace Assembly
if you have left the bolts loose that connect the Braces and Center Legs. If they are tight, you
must loosen them at this point.
¾
Standing at the Left End of the frame, push the frame all the way in so th
¾
Check each rail to make sure they fit
Parts Needed: 1 – Right and Left Angled Leg Brace
2 – ¼” x 45 mm Connector Bolt
2 – Rectangle Nuts
1 – Alan Wrench
¾
Connect the right and left Angled
Brace to the Front Legs of the frame
by putting a 45mm connector bolt
through the front leg and into the slot
in the Angled Brace.
¾
Put a rectangle nut in the cross slot
in the brace and thread the bolt
through it.
¾
Tighten the connector bolt using
the Alan wrench.
¾
You
will attach
angle
brace to the
table top in
the next
step.
the top of
the
note letter
15
Left Side of Frame
Inside View
rectangle nut
45mm
Connector
bolt
Left Side of Frame
Inside View
note letter
rectangle nut
45mm
connector
bolt
