¾
Plac
was
½” Spacer), another flat
washer, and a nylock nut. This washer and nylock nut will go into the pocket of the ¾” Spacer.
¾
¾
¾
¾
e a flat washer on the end of the 70mm connector bolt, followed by the ½” Spacer, another flat
her, the ¾” POCKETED Spacer (with the pocket facing away from the
Tighten the nut completely.
Now put the Front Speed Control Lever onto both bolts: place the slotted end onto the 70mm bolt and
the middle hole onto the 40mm bolt.
Put a flat washer and nylock nut onto the end of the 40mm bolt and tighten. Then un-tighten as done
to previous nylock nuts.
Finally, place a flat washer and nylock nut onto the end of the 70mm bolt. Tighten and then slightly un-
tighten the nut.
NOTE: The Front Speed Lever Contol should be loose enough to slide back and forth freely against
the pocketed spacer.
28
