Leg/Table Support Assembly
¾
Now connect the Table Tops to the Front Leg Support
installed in Step10.
¾
Line up the top of the support brace with its corresponding
hole in the Left and Right Table Sides.
¾
Insert a 45 mm connector bolt and rectangle nut and
completely tighten using an Alan wrench.
Step 14: Track Installation
you
45mm connector
bolt
rectangle nut
Parts Needed: 1 –60” Track
1
–52”
Track
the top and bottom grooves.
left
, as pictured above.
t thr
on-thr
slightly bigger hole (they should be the only two left!
¾
flat
head so that it sits flush against the edge of the trac
2
–20”
Track
*2 –34” Track
2 –1/4” x ¾” Hex
Head Bolts
2 – ¼” Flat washer
2 –Unthreaded
Rectangle Nuts
2 –1/4” Wing Nuts
*queen size only
¾
Start on the right side and place the
52” Track into the top track groove
(closest to the rails).
¾
Place the 60” Track into the bottom track groove and slide it all the way to the right.
,
next insert one 34” track into
slide hem a
For both crib and queen size assembl
the top and bottom grooves and
y, place a 20” Track into
Place these pieces to the furthest
You will secure these tracks in place by placing a ¾” hex head
Left Angled
Leg Support
Brace
Crib size
52 inch
track
60 inch
track
20 inch
track
¾
If you are doing the queen size assembly
lace.
t
gainst the tracks in p
¾
¾
bol
ough a non-threaded rectangle nut and then through the
hole at the left side of the Left Table Top.
NOTE! The
eaded
rectangle nuts have a
edge of the bolt
k.
Left Side of Frame
1/4 X 3/4
hex bolt
unthreaded
rectangle nut
1/4 flat
washer
1/4 wing
bolt
Outside View
¾
n
Once through the hole, line up the
17
