Step 6: Pole Mount End Hardware Install
ount
1 – Left Pole Mount
lts 4 – Roller Bushings
4 – 5/16” Jamb Nuts
¾
The Pole Mount Ends are designed to be adjustable both for height and front to back positioning.
¾
As you install two carriage bolts into each of the Left and Right ends, keep in mind the following:
1.
Be sure the bolts are put through th
of the part.
tightened. The roller
bushings will fit loosely on
the bolt.
Parts Needed: 1 – Right Pole M
4 – 5/16” x 2” Carriage Bo
4 – 1/4” Flat Washers
Left Pole Mount End
Insid
arriage bolt
5/16 jamb
nut
roller
bushing
e Pole Mount Ends so the heads show on
the inside
2.
Each carriage bolt can be placed in one of seven
matching
holes.
(i.e. If the front bolt
placed in hole #1, the back bolt must also be placed in ho
is
le #1).
sitioning is achieved by placing the two carriage
in the center (#4) holes (each in the hole fourth from the front). This is based on a
machine with a throat length of about 7 inches.
t to reposition the rails by placing the bolts in
the throat of the machine, the closer the bolts should be
to the front (holes #1, #2 etc.)
5.
The jamb nuts should be
completely tightened with a
wrench.
6.
The nylon roller bushings
should be placed on the
bolts after the jamb nuts are
Right Pole Mount End
5/16 X 2
carriage bolt
1/4 flat
washer
5/16 jamb
nut
roller
bushing
1
2
4 3
5
6
7
3.
A good average setting for front-to-back rail po
bolts
4.
Depending upon the machine you may later wan
different holes. A good rule of thumb
is the bigger
e view
5/16 X 2
c
1/4 flat
washer
6 7
1 2
3 4
5
1 2
3
4 5
6 7
7 6
5 4
3 2
1
11
Inside View
