Giken GSK Series, Instruction Manual, Page: 71 / 109

70
７－１４ （
Fn.04
）
Operation instruction from GSK drive
The write operation of Fn4 will be the operating instructions for the GSK interface.
Set the operation type to Fn4-00 and the data number to Fn4-01, and it will execute the following operations by
the long press the left arrow button.
Number Matter Description
Fn4-.00 Operation type
1: The final tightening result print start
2: Special Operation
Fn4-.01 Data number
This becomes a different meaning by the operation type.
[In the case of operation type = 1]
Unit number (1 to 7).
[In the case of operation type = 2]
Special operation for debugging
1: It will allow the special operation
★
1
2: SETTING.BIN file save (GSK interface
⇒
SD)
3: SETTING.SD file save (GSK interface
⇒
SD)
4: Preliminary
5: SETTINGS.BIN file read (SD
⇒
GSK)
★
2
6: SETTING.SD file read (SD
⇒
GSK)
7: Preliminary
8:Communication port exchange of debugging and PC
communication (RS232C
→
USB).
★
1: Only just after writing in "1" for wrong operation prevention, after 2 moves.
For example, when you want to save the SETTING.BIN file, please do in the 1 → 2 of the order.
You need to do from writing again "1" If you perform another operation.
★
2: After the end of a read, please cut the powersupply and turn on the power of GSK interface after that.
７－１５
(Fn.5) unit setting
Number Matter Setting range
NO.□□
The □□ is axis number.
Please set each axis belongs the unit number to Un-
○○.
The set value of the unit will be the station number of SIO.
Please be sure to set "Un.01" as an axis with the interface unit.
To the axis of the shaft cut is set to "Un._-" the unit number.
Un.01
～
Un.07
Un.
－
No.- Save at once all of the data of Fn.11 at the SAVE button.
―
【
Caution
】
Please the power of always GSKIF after changing the unit set to the OFF / ON.
GSK system does not correspond to change the unit configuration while the power is ON.