Giken GSK Series, Instruction Manual, Page: 68 / 109

67
７－１０
Point setting
It will remember the XY coordinates of each unit in the form of a point number.
If GSKIF instructs the move to GSK driver, specify the point number, not the coordinate value.
Number is the number of the case to be set from GSK driver panel (= x-yyy-z).
The x is the unit number (1 ~ 4), yyy is point number (1 ~ 255), z indicates the axis type.
Number
(yy)
Matter
Setting
range
Increments
No.000
～
No.254
Point coordinate value (Point number1
～
255)
Set the coordinate values of the point of the X-axis.
※
Axis type (z):0 is the X-axis, 1 is the Y-axis.
0000-9999 0.1mm
No.255 Reserve
― ―
No256
Set the adjacent interference distance 1 to 8.
The combination of the unit number (x) and the shaft type (z) shows the
following value.
Unit number(x) Axis type(z) Meaning
1
0
1 Adjacent interference distance 1
Adjacent interference distance 2
2
0
1 Adjacent interference distance 3
Adjacent interference distance 4
3
0
1 Adjacent interference distance 5
Adjacent interference distance 6
4
0
1 Adjacent interference distance 7
Adjacent interference distance 8
― ―
No257
Set the soft limit (+ direction).
Set the upper operating limit coordinate value according to the unit
number (x) and the shaft type (z).
― ―
No258
Set the adjacent interference distance 9 to16.
The combination of the unit number (x) and the shaft type (z) shows the
following value.
Unit number(x) Axis type(z) Meaning
1
0
1 Adjacent interference distance 9
Adjacent interference distance 10
2
0
1 Adjacent interference distance 11
Adjacent interference distance 12
3
0
1 Adjacent interference distance 13
Adjacent interference distance 14
4
0
1 Adjacent interference distance 15
Adjacent interference distance 16
― ―
No.259
～
No.266
Each individual operation interlock setting
(GSK is not used because it has no function.)
― ―
No267
Adjacent interference check invalid setting
BIT1
0:check 1:not check
※
Note that the check "to" 0
― ―
No268
Set the soft limit (- direction).
Set the lower operating limit coordinate value according to the unit
number (x) and the shaft type (z).
― ―
No269
～
No.287
Reserve
― ―