Giken GSK Series, Instruction Manual, Page: 54 / 109

53
７－３
Socket-fittings setting
It is the setting for performing screw tightening before the preparation operation. (Numbers 1 to 50)
Bolt picked up, it performs a gear check, fitting, etc., and then to state that can be screw-tightening.
Number is the number of the case to be set from GSK driver panel (Axx-yy)
Number
(yy)
Matter increments
No.00
Rotation angle
To set the rotation end angle.
1 degree
No.01
Speed
Setting the rotation speed.
1rpm
No.02
Rotate / inching direction, fitting, gear check
00 * □
|∟---------Rotation / inching direction specified
| 0: rotation to the tightening direction
| 1: Rotation Loosen the direction
+ --- Torque judgment / fitting / gear check
0: No torque judgment
1: One-shot reversal
2: Fitting
3: Gear Check
－
No.03
Detection torque
During the rotation, it reaches the set value, and exit the rotation. If you do not reach
even beyond the cut angle will be the "fitting angle over".
0.1Nm
No.04
Before time
From rotating operation start, after a set time, we actually begin to operate.
1msec
No.05
Over time
When "setting time" elapsed from the rotation start, it completes the operation if in
operation. (Not including before time)
1sec
No.06
― ―
No.07
― ―