Giken GSK Series, Instruction Manual, Page: 31 / 109

30
４．
Signal
４－１
Input and output signals
Parallel I / O
I/O Points Signal name Specification Contents
Parallel
input signal
48 IN1~IN48
DC24V
11mA
Used for exclusive Anybus board installation.
Parallel
output signal
48 OUT1~OUT48
DC24V
30mA max
Serial I/O
I/O Note Management
ARC-NET
Installation of terminating
resistor 110 Ω is required Inter-controller communication during multiaxis control
(to be crossed by COM)
CC-LINK
Used for exclusive board
installation on Anybus
Communication of tightening management with PLC
Devise-NET
Used for exclusive board
installation on Anybus
Communication of tightening management with PLC
Analog monitor
Output item Matter
M1
Output the date of torque, speed and current by the panel operation
Monitoring of the torque sensor
（ ≒
5V/sensor rate
）、
Scaling of the current(10A/10V)
Monitoring of the motor rotation speed
（
Output plus value when it rotates to the right
）
M2
※
You can change the above in the operation of the setting panel.
（
See PageNo..81
）
I/F unit
I/O Points Matter
USB 1
Parameters and various data
inputs and outputs data from the connection PC
Centronics
or RS422
1
or
2
Connecction the printer or ID controller and Quality control PC
(You cannot connect connect the printer when ID controller and Quality control
PC are connected)
RS422 1 Connection the display.
RS485 1 The interface is connected at [Serial Input/Output]to a seaquencer , etc.