GE HEALTHCARE CARESCAPE Monitor B450, Technical Manual

Page: 195 / 236

Disassembly and reassembly
187
2062973-003
12.2.7 Detaching the uDOM
Disassemble first:
a.
12.2.6. Detaching the front unit and mid-frame assembly from the rear unit assembly
Keep the rear unit assembly on the table, the
device label side facing down.
1. Carefully detach the uDOM from the CPU
assembly. The uDOM is connected to the CPU
assembly with a connector from one and with
a nylon support post from the other end. You
may need pliers to squeeze the nylon support
post a little to detach the uDOM.
NOTE: uDOM, disk on module is the permanent
memory of the patient monitor. The software,
licenses and clinical and service configurations
are stored to the uDOM.
•
Reassemble in reverse order.
uDOM replacement:
Contact GE Service if you doubt that the uDOM is defective and needs to be replaced. Some of the
configuration steps required after uDOM replacement can be performed only by GE service.
Provide the following information:
a) Monitor Type
b) Serial Number
c) Software version installed, if available.