9
GC32FLEX
GC32FLEX/TSI SAFETY AND OPERATION MANUAL
CRIMPER SET-UP
1.
Remove 4x mounting bolts using a 5/8” (16mm) Wrench.
2.
GC32FLEX Lifting and Movement (Forklift Option)
Lift the machine off the pallet using a forklift.
Always ensure that designated tine channels are used when moving
or lifting the machine.
Place the machine on a suitable bench, or the GC32FLEX crimper
stand (7482-0017).
3.
GC32FLEX Lifting and Movement (Sling Option)
Remove the tabs in the middle of the tray on both front and rear
using a flat head screwdriver.
Attach an appropriately rated sling through the left side forklift
channel.
Attach another appropriately rated sling through the middle of the
cut-out channel from the front to the rear.
4.
GC32FLEX Lifting and Movement (Sling Option)
Lift using both slings attached to a crane or hook.
Do not lift the GC32FLEX with 2 slings in the left and right forklift
channel. The Crimper centre of gravity is over the head - it will
lean to one side. Move slowly during lifting to avoid excessive
swinging.
Secure to the crimper stand or bench with 4x 5/8” (M10) Bolts/
nuts/washers.
Lifting Slings not included.
LIFTING AND INSTALLATION - GC32FLEX (HEAD ON TRAY) ONLY
Do Not Sling or Lift machine by the head as this will cause damage to the crimper.
See Crimper Specifications for the Gross Mass of the GC32FLEX Machine.
!
