25
4
Remove protective caps
from molecular sieve.
Retain for future use.
Protective caps should be put on gas sockets in case the device is stored
or transported.
Make sure that the power switch is set to OFF before connecting the
power supply.
5
Connect
device
to
power supply. Connect
power supply to power
socket.
Only use stainless steel pressure reducers, PTFE tubes with 3 mm outer
diameter and 3 mm Swagelok connectors.
Screw on the Swagelok caps manually and fix them by screwing a further
half-turn using a 12 mm open-end wrench.
Make sure that the nominal pressure of the nitrogen source does not fall
below 10 bar (1000 kPa).
Do not introduce aggressive gases or liquids into the device.
2x
Y
Summary of Contents for GC-IMS-SILOX
