Questions? Please Contact Your Local Manufacturer’s Representative
4-11
SECTION 4
ModSyncSE-User-Manual-211020
NETWORK
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
4. Select the ‘Network’ tab from across the bottom of the screen. And then
‘MODBus’ from the available options.
5. Select the ‘Serial Slave’ Icon from the top of the screen. You can then
change the ‘ID’ to the desired Modbus Address. Note that the Baud Rate is
set to 19200 and cannot be changed.
6. To Return to the Boiler Operation Screens. Press and hold the screen in the
top right corner until the drop down menu appears and select ‘UserApp’.
