© Fulton Group N.A., Inc. 2021
4-2
NETWORK
ModSyncSE-User-Manual-211020
SECTION 4
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
Network Parameter Configuration and
Address Listings
The ModSync® Sequencing System provides a Modbus interface to communicate
the status of each condensing boiler in the hydronic heating loop to a Building
Management System. This network can also be used to receive a system enable/
disable and remote setpoint commands from the Building Management System.
BACnet and LonWorks options are also available with the use of respective
protocol converters.
The following table details the communication parameters and the ModSync®
addresses available for the ModSync®.
*Please contact Fulton to request a points list mapped for your equipment.