Questions? Please Contact Your Local Manufacturer’s Representative
4-7
SECTION 4
ModSyncSE-User-Manual-211020
NETWORK
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
The Gateway must also be enabled and have the COM port selected for the same
port that was configured above. See image below.
***Select ‘Save’ before leaving the Setup screen otherwise new settings will not
take effect.
***Cycle power to the panel; this will refresh the ports and make sure that the
new settings are in effect.