Questions? Please Contact Your Local Manufacturer’s Representative
3-35
SECTION 3
ModSyncSE-User-Manual-211020
OPERATION
!
WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the staff responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
on a user defined number of run hours. The pump with the fewest number of
run hours will become lead. The lead pump will run at all times until the outdoor
air temperature is above the user defined outdoor air temperature setting or the
system is disabled.
Mode:
Auto/Manual selection. In Auto mode the ModSync® will
determine when the system pumps should be operated. If the mode
is selected as Manual then the pump will only respond to the manual
selection.
S
tatus:
Displays the current status of the system pump.
Manual Control:
Provides Manual control of the Pump when the
mode is set for Manual.
Constant Speed System Pumps 2
Pump off Delay
: When the outdoor air temperature is above the
outdoor air temperature cutoff, the pumps will be disabled after the
pump off delay.
Hours to Auto Rotate:
Number of hours the lead System Pump runs
before the lead lag sequence will be recalculated.
FIGURE 34 – CONSTANT SPEED SYSTEM STATUS
FIGURE 35 – CONSTANT SPEED PUMP CONFIGURATION SCREEN