Fujitsu Airstage AGUA12TLAV1, Design & Technical Manual

Page: 685 / 978

„ „
SETTING UP EACH INDOOR UNIT
00 01 01 01 02 01 13 01 14 01 15 01 0 1 2 0 1 0
Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit
Repeat the procedures in steps 1) through 13), and set up the indoor units
requiring address setting.
Simple remote
controller
Simple remote
controller
Simple remote
controller
„ „
RESET THE POWER AFTER SETTING UP ADDRESS OF ALL
INDOOR UNITS
Important
„ ¾
If the reset is not performed, address cannot be read in normally.
„ ¾
After all the addresses have been set, the circuit breaker needs to be switched off
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
„ ¾
The set address is stored in the PCB and will remain in memory even when the
power is turned off.
However setting address is effective after power reset.
Record the address set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
- (07 - 38) -
FUN
C
TI
O
N
SE
TTI
N
G
FUN
C
TI
O
N
SE
TTI
N
G