Fujitsu AB* A12GATH, Design & Technical Manual

Page: 23 / 1124

1. MODEL SELECTION PROCEDURE
Selection of indoor units
See 2-2.MODEL LINE UP (INDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-1.MODEL LINE UP (OUTDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
Selection of required optional parts
● Cassette grille for all Cassette type
● EV kit for AS

E004-009,12,14 and AG

E004-014
Selection of controller units
● System Controller
● System Controller Lite
● Touch Panel Controller
● Central Remote Controller
● Group Remote Controller
● Wired Remote Controller
● Simple Remote Controller (with operation mode)
● Simple Remote Controller (without operation mode)
● Wireless Remote Controller
Selection of adaptor / convertor
● Network Convertor
● Network Convertor for L
ON
W
ORKS
®
● KNX Convertor for VRF
● KNX Convertor for INDOOR UNIT
● Modbus® Convertor for VRF
● Modbus® Convertor for INDOOR UNIT
● BACnet® Gateway
● Wireless LAN adapter
● Signal Amplifier
● External Switch Controller
Selection of branch kit
● Separation Tube
● Header
END
Selection of other optional parts
● Flange (square)
● Flange (round)
● Long-Life Filter
● IR Receiver Unit
● Remote Sensor Unit
● Drain Pump Unit
● Air Outlet Shutter Plate
● Panel Spacer
● Wide Panel
● Half concealed kit
● Insulation Kit for High humidity
● Fresh air intake kit
● Auto louver grille kit
Selection of outdoor unit
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
- (02 - 01) -
MOD
EL
SE
LE
C
TI
O
N
MOD
EL
SE
LE
C
TI
O
N