Frigidaire FFLE3911QW, Technical & Service Manual

Page: 49 / 195

48
Connecting Drain and Electrical
1. Form a “U” shape at the end of the drain hose with the
hose pointed towards the drain. Place the “U” shape end in
a laundry tub or a standpipe and secure the drain hose with
the cable tied (provided in the enclosure package) to the
standpipe, inlet hose, laundry tub, and so on, so that the
hose does not come out due to the force of the water.
2. Plug the power cord into a grounded outlet.
3. Turn ON the power at the circuit breaker / fuse box.
4. Read the Use and Care Guide provided with the Laundry Center. It contains valuable and helpful information that will save
you time and money.
5. Run the washer through a complete cycle, checking for water leakages and proper operation.
6. If you have any questions during initial operation, review the “Avoid Service Checklist” in your Use and Care Guide before
calling for service.
7. Place these instructions in a location near the appliance for future reference.
NOTE
The standpipe inside the diameter must have a
minimum circumference of 1-1/4” inches (3.2 cm).
There must be an air gap around the drain hose
in the standpipe. A snug hose fitting can cause a
siphoning action.
IMPORTANT
Ensure that the power is switched OFF at a circuit
breaker / fuse box before plugging the power cord
into an outlet.