Freedom R8100 SERIES, Operator'S Manual

Page: 156 / 255

156
Transmit Offset
Set the frequency offset from the radio receive frequency to the radio transmit frequency in MHz using
the ▲▼ (Up/Down), and ◄► (Left/Right) keys, numeric keypad, and spin knob. Conversely, the setting
defines the offset from the base station transmit frequency to the base station receive frequency.
Radio TX frequency = Radio RX fre Transmit Offset
Base Station TX frequency = Base Station RX frequency - Transmit Offset
System Code
Set the System Code within the NXDN™ system being tested. The range of values is from 000 to 999.
Alpha numeric entries are made using the ▲▼ (Up/Down), and ◄► (Left/Right) keys, numeric keypad,
and spin knob.
Site Code
Set the identity of the site within the RF Subsystem. The range of values is from 0 to 9. Alpha numeric
entries are made using the ▲▼ (Up/Down), and ◄► (Left/Right) keys, numeric keypad, and spin knob.
Unit ID
Set the temporary Unit IDentity assigned by the R8100 to the subscriber unit being tested. The range of
values is from 0 to 65535. Alpha numeric entries are made using the ▲▼ (Up/Down), and ◄►
(Left/Right) keys, numeric keypad, and spin knob.
Group ID
Set the temporary Group IDentity assigned by the R8100 to the subscriber unit being tested. The range
of values is from hexadecimal 0 to 65535. Alpha numeric entries are made using the ▲▼ (Up/Down),
and ◄► (Left/Right) keys, numeric keypad, and spin knob.
Bit Rate (bps)
Select the system communication bit rate as 4800 bps or 9600 bps. 4800 bps is used for 6.25kHz systems
and 9600 bps is used for 12.5kHz systems.
Voice Playback
Set the state of the Voice Playback feature. When the voice playback feature is turned ON, voice traffic
from the radio is recorded. At the end of the radio’s transmission, the R8100 will initiate a voice call to
the radio a replay the recorded audio. The feature may be turned OFF if audio playback is not desired.