Selecting a child restraint system
To provide protection, a child restraint
system should meet three requirements.
1.
The child restraint system complies
with Australian Standard AS1754.
Infants and children must be properly
restrained at all times in an approved
child restraint which conforms to
Australian Standards AS1754-2004 or
later. Look for the Australian Standard
Approval Mark on the child restraint.
2.
The child restraint must be suitable
for the size and weight of the child
and must be properly fitted and
adjusted.
Rearward facing restraints
are suitable for babies, and forward
facing child restraints are suitable for
small children. Use the child restraint
exactly as shown in the instructions
provided with the child restraint. If you
have any doubts, contact the child
restraint manufacturer or consult an
approved Restraint Fitting Station.
3.
The child restraint system should
fit the vehicle seating position (or
positions) where it will be used.
Due to variations in the design of child
restraint systems, vehicle seats and
seat belts, all child restraint systems
may not fit all seating positions. Before
purchasing a child restraint system, it
is recommended that the child restraint
system is tested in the specific vehicle
seating position (or positions) where
it is intended to be used. If a previously
purchased child restraint does not fit,
you may need to purchase a different
one that will fit.
CHILD SAFETY LOCKS
Manual Child Safety Locks
WARNING
You cannot open the doors from
inside if you have put the child safety
locks on.
E112197
The childproof locks are located on the
rear edge of each rear door and must be
set separately for each door.
Note:
On vehicles with keyless entry, use
the spare key.
Left-Hand Side
Turn counterclockwise to lock and
clockwise to unlock.
Right-Hand Side
Turn clockwise to lock and
counterclockwise to unlock.
21
Ranger (TKE) Vehicles Built From: 01-12-2014, DB39-120609-JB enAUS, First Printing
Child Safety
