Flylight Nynja Build, Manual

Page: 94 / 265

94
h) Secure the stop-rings with adhesive such as epoxy or silicone.
i) Attach the rudder cables to the pedals, using the stainless tangs that have
several adjustment holes in them.
The cable from the starboard-side pedal is the one which passes
through the starboard-most pulley in the group of four. Note the cable
routing for the starboard cable shown in Figure 115 which passes to the
outside of the central brace angle.
Make sure the rudder cables pass over the flap handle mount and over
the flap linkage at the rear end of the flap handle.
.
If they pass beneath the linkage the flap handle will push the cables
downwards when you deflect the flaps.
j) Attach the rudder cables to the rudder horn, crossing them on the way
back in the rear fuselage so that the starboard cable at the pedals attaches
to the port rudder horn and vice-versa.
Where the cables cross ensure the cable from the port side at the front
is above the starboard cable. The port cable is then lifted up with the
addition of a P clip fairlead as shown in Figure 110 below to help with
clearance
Figure 110 Port rudder cable fairlead
k) Connect the rudder centring cables, a pair of steel cables connected
together at one end, to the shackles on the rudder horn using the other
ends
P clip fitted on flap pivot bolt to
act as fairlead for port rudder
cable. Note washer removed
below nut to facilitate fit.