92
a) Assemble the 4 pulley Block as shown in Figure 107 above. Note that the
starboard most plate just has a single saddle washer between it and the
TU19.
Pass through the control cables as shown in Figure 107. Rudder cables
are not handed. The tangs with lots of holes connect to the rudder pedals.
The elevator cable with a turnbuckle at one end should be fitted with
the turnbuckle end to the rear and the front end to the upper attachment
hole on the control stick. The other elevator cable has a turnbuckle mid
length and fits to the upper end of the elevator horn and lower
attachment hole on the stick.
Check that - A single metal washer should be in position on both sides
of each pulley to provide a small amount of clearance from the side
plate, not more than 1mm. A spacer tube should be in position on the
pivot bolt to keep the side plates parallel.
Don‟t forget the flap detent lever retaining plate and its spacer tubes.
The trimmer cable bracket attaches to the forward end of this and can
be fitted at this time.
The control stick may have more than one set of cable attachment
holes. If so the pair closest to the stick pivot should be used.
Figure 108 Nynja elevator cable connection on control stick. (Note: hole closest to pivot used,
and that a thin plastic washer is fittedbetween tang and stick)
b) Tighten up the bolt passing through the pulley bearings
c) Looking rearwards. The rudder cables are the lowest, with the elevator
cables passing above them.
Summary of Contents for Nynja Build
