Flylight Nynja Build, Manual

Page: 144 / 265

144
a) Assemble the mounting plates and drill and temporarily fix with clecos /
skinpins to the cabin uprights tu34 .
The plates should be fixed with top hole 420mm above the centre of the
lower fixing bolt on the cabin uprights
– see fig 173 below
b) Temporarily assemble the levers onto the plates. Check correct position of
cabin upright spacing. Torque tube is supplied over long, so offer it up, mark
and cut to length.
c) Rivet the port lever pivot into the torque-tube using eight 3.2 x 10mm steel
rivets.
Do not drill within 12mm of the end of the tube. There should be two rings of four rivets each,
Verify the alignment of the levers before riveting the starboard lever in place.
Figure 172 throttle torque-tube rivets.
.
Figure 173 throttle plate fixing dimensions
420mm