Flylight Nynja Build, Manual

Page: 123 / 265

123
Figure 148 cable routed through U-bracket.
e) Pass the cables around the pulleys at the top of the front vertical tube tu14
where the leading edges attach, Figure 147.
f) Prepare the fittings for attaching the aileron cables to the driving horn
connected to the control stick.
The Nynja may be supplied with Aileron cables with derig connections
on the sections from the pulleys on top of the TU14 tube where they run
along behind the front wing spar tube before entering the wing. If these
are fitted then the cables attach to the driving horn using the shackles
as supplied and as shown in drawing figure 147 above, and the
following down to j) can be disregarded:
If using the full length cables, attach a pair of the stainless steel plates
to the port aileron cable using a shackle pin and two plastic washers on
the outside of the plates to take up some of the slack, and permanently
secure with a split pin, figure 159.
Attach the other pair of stainless steel plates to the starboard side of
the aileron driving horn, again using a shackle pin with a pair of plastic
washers outside the plates, permanently secured with a split pin.