Fluke NORMA 4000 Operators, User Manual, Page: 121 / 184

Remote Control - Description of Commands
Commands and Queries
4
4-73
combination of one or more of the following values (bits) combined together using
logical OR operation:
0 Normal
Valid measurement, no questionable condition.
1 Underrange
The returned value is valid, but the signal amplitude is too low for the given range, so
the measurement precision is reduced.
2 Overrange
The instrument returns a measurement value, but the input signal amplitude is too high
for the given range. This causes the input signal to be clipped to an amplitude within
the current range. Because the measurement value is calculated from clipped sampled
data the returned value can be more or less outside the specification.
8 Undefined
The instrument was not able to calculate a valid value. This could be caused by e.g.
loss of synchronization (no valid frequency, harmonics, ...). The instrument returns an
Not A Number for the measurement.
16 Not available
The requested function is not or no longer available (e.g. option not installed, function
turned off). The instrument returns an Not A Number for the measurement.
128 Power Factor capacitive
For the Power Factor function this indicates capacitive phase difference between
voltage and current (0 = inductive).
Response
When FORMat:TRANspose is ON, values are grouped by functions:
<interv1>,<interv2>,...<interv1>,<interv2>,... <interv1>,<interv2>,...<interv1>,<interv2>,…
func1
func2
func1
func2
...
When FORMat:TRANspose is OFF, values are grouped by intervals:
<func1>,<func2>,...<func1>,<func2>,... <func1>,<func2>,...<func1>,<
func2>,…
interval1
interval2 interval1 interval2
...
data
status
*RST state
There is no response to this command after reset.