6.
Slide the duplex fiber-optic cable connector (3, above) into the
SFP module until you hear a positive
Click
sound.
7.
Slide the round threaded tube forward along the fiber-optic cable.
Screw the tube onto the port connector by hand (below).
4.2.2. Connecting a DC IN power source to the unit
NOTE
If the unit must be powered using an IEEE 802.3at-compliant
network switch or PoE injector, disregard this section and
proceed to
“Connecting LAN cables to the unit” (page 36)
.
When the Fluidmesh 4200 FIBER is mounted in its final location, connect
the unit to a 48V DC IN power supply by doing the following steps:
1.
Only use a power cable that terminates in an M12A connector to
connect the power source to the unit.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 35 of 180
