Fluidmesh 4200 FIBER, Installation And Configuration Manual

Page: 131 / 180

6.6.13. Miscellaneous settings
IMPORTANT
Support for FIPS, CANBUS, PROFINET and QNET are only
available if the corresponding plug-ins are installed. If the
corresponding plug-in is not installed, the check-box for the
relevant option will not be available.
The following plug-ins are needed to activate these features:
• FIPS: FM-FIPS
• CANBUS: FM-CANBUS
• PROFINET: FM-PROFINET
• QNET: FM-QNET
Note that FIPS support is not available for the FM 1000 and
FM 10000.
Contact your Fluidmesh Networks representative for details.
The MISC SETTINGS window contains controls to change the following
settings:
• The device name, as used to identify the Fluidmesh 4200 FIBER
within the FMQuadro network map and to other Fluidmesh utilities.
• The operation of the physical Reset button on the unit.
• Device firmware upgrades by trivial file transfer protocol (TFTP).
• The unit's federal information processing standards (FIPS) 140-2
compliance settings (if applicable).
• The unit's controller area network (CANBUS) support settings (if
applicable).
• The unit's process field net (PROFINET) support settings (if
applicable).
• The unit's Neutrino Qnet (QNET) support settings (if applicable).
To change any of the miscellaneous settings, do the following steps:
1. Click the -misc settings link under ADVANCED SETTINGS in
the left-hand settings menu.
• The MISC SETTINGS dialog will be shown ( Figure 65
(page 132) ).
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC Page 131 of 180