OBID
i-scan
®
Manual
ID ISC.PRHD102
FEIG ELECTRONIC GmbH
Page 94 of 125
H71101-2e-ID-B.doc
DB-SIZE:
Number of bytes of one data block.
DB:
Data of the data block to be written to the Transponder. The required block size is defined
by DB-SIZE. The number of the expected bytes are DB-N * DB-SIZE.
ISO15693 ERROR:
(only ISO15693 Transponder)
ISO15693 ERROR code of Transponder response. This byte is only available if STATUS
= 0x95.
DB-ADR-E:
Block number where the error occurred.
Notes:
•
If an error occurred during a write command, the number of the block were the error oc-
curred will be send to host
•
EPC Class 1
– before you can write on the EPC Class 1 Gen 1 Transponder the Transponder need to
be erased/killed.
– To erase the EPC Class 1 Gen 1 Transponder you should force a write operation on
address 0xFF.
– the EPC Class 1 Gen 1 Transponder should be written in the non addressed mode
– The address 0 is the CRC of the EPC class1 Gen1 Transponder
– The block size should be set to 2.
•
ISO15693:
– A write to 1 block uses a Write Single Block command to the Transponder. This will be
managed by the Reader internally.
– If a Transponder does not support Write Multiple Blocks commands several Write
Single Block commands are used for this Transponder.
Summary of Contents for OBID i-scan ID ISC PRHD102
Page 77: ...OBID i scan Manual ID ISC PRHD102 FEIG ELECTRONIC GmbH Page 77 of 125 H71101 2e ID B doc...
Page 78: ...OBID i scan Manual ID ISC PRHD102 FEIG ELECTRONIC GmbH Page 78 of 125 H71101 2e ID B doc...
Page 79: ...OBID i scan Manual ID ISC PRHD102 FEIG ELECTRONIC GmbH Page 79 of 125 H71101 2e ID B doc...
Page 80: ...OBID i scan Manual ID ISC PRHD102 FEIG ELECTRONIC GmbH Page 80 of 125 H71101 2e ID B doc...